Lesson 2: Tools, Safety Gear and Dust Containment

DIY Homeowner’s Guide · Lesson 2 of 6

Before removing any floor, set up three things: the right tools for your floor type, protective gear for your lungs, eyes and hands, and a sealed work area that keeps dust out of the rest of the house. Containment is what separates a clean project from a home coated in dust. It takes an hour to set up and saves days of cleaning.

Protective Gear

  • Respirator: tile, grout, mortar and concrete contain crystalline silica, which causes serious lung disease when inhaled as fine dust. Wear a NIOSH-approved respirator. For breaking tile or grinding concrete, a half-face respirator with P100 filters is the standard choice. A loose paper dust mask is not enough.
  • Eye protection: safety glasses or goggles. Tile shards fly.
  • Hearing protection: rotary hammers and grinders are loud enough to damage hearing.
  • Gloves, long sleeves and boots: broken tile edges are as sharp as glass.
  • Knee pads: you will spend hours on the floor.

Tools by Floor Type

  • All jobs: pry bar, hammer, utility knife, flat shovel, contractor bags or buckets, and a HEPA-filter shop vacuum.
  • Tile: a 4-pound hand sledge and cold chisel for small areas, or a rented rotary hammer with a wide chisel bit for larger rooms. A floor scraper helps with loose tile.
  • Hardwood: a circular saw with the blade set to the board thickness, a flat bar, and pliers or a nail puller for leftover fasteners.
  • Adhesive and thinset: a long-handled floor scraper. Grinding concrete is best left to professionals with dust-shrouded grinders (Lesson 5).

Setting Up Dust Containment

  1. Turn off the HVAC system and cover every supply and return vent in the work area with plastic and painter’s tape. Dust pulled into the ductwork spreads through the whole house.
  2. Seal doorways with plastic sheeting from floor to ceiling. A zipper door kit lets you get in and out without breaking the seal.
  3. Protect what stays in the room: cover cabinets, tubs and fixtures with plastic, and tape cardboard or hardboard over finished floors you will walk across.
  4. Control dust at the source: lightly misting tile and mortar with water before breaking it keeps dust down. Vacuum debris with a HEPA vacuum as you go.
  5. Never dry sweep or use a leaf blower. Both put fine dust straight back into the air.

Professional crews add air scrubbers, which are fans with HEPA filters that clean the air in the work zone. Some rental shops carry them, and they are worth it on large tile jobs in an occupied home.

Lesson 2 Checklist

  • I have a NIOSH-approved respirator with P100 filters, plus eye and hearing protection.
  • I have the tools for my floor type and a HEPA-filter vacuum.
  • The HVAC is off and the vents in the work area are sealed.
  • Doorways are sealed with plastic and fixtures are covered.